Applied Sciences
OPEN ACCESS
Increase The Wear Resistance And Service Life Of Dyes Based On Modern Technologies
DOI
Crossref DOI
10.37547/tajas/Volume02Issue12-19
tajas
2020
VOL. 2
/ NO. 12
DECEMBER
RESEARCH OVERVIEW
Abstract
The main ways to increase the durability of the working parts of the stamping tool are considered, including the processes of cold plastic deformation during the application of wear-resistant coatings by ion-plasma spraying. A physical model of the process of cold plastic deformation of samples from heat-resistant steel X12M is presented.
RESEARCH TOPICS
Keywords
Stamp
mold
mechanical activation
Downloads
Download data is not yet available.
SOURCES & SCHOLARSHIP
References
- Increasing the durability of working surfaces of parts of dies and molds made of heat-resistant steels. Morozov O.I., Tabakov V.P., Kokorin V.N., Titov Yu.A. Bulletin of the Tula State University. Technical science. Issue 11: at 3 pm Ch1. Tula: Publishing house of Tula State University, 2017.64-68 p.
- Odintsov L.G. Strengthening and finishing of parts by surface plastic deformation: a reference book. M .: Mashinostroenie, 1987.S. 70-116. 324
- Chernyavsky A.O. Finite element method. Basics of practical application. FSBEI HPE "SUSU" (NRU). [Electronic resource]. URL: http://pent.sopro.susu.ac.ru/LRN/0711/smm/files/ fea_4c.pdf
- Wang H. et al. Direct and continuous strain control of catalysts with tunable battery electrode materials, 2016. Science 354. P. 1031-1036.